MUTOH ValueJet 1304, User Manual

Page: 47 / 124

User’s Guide ValueJet 1304
Handling the printer
AP-75780 - Revision 1.3 47
4
Step 2:
Perform an initial adjustment print.

Press
ENTER
.

“FeedLenght: 250mm” is displayed.

Press
ENTER
.

“Printing” is displayed.

Start Initial adjustment printing.

When the initial adjustment printing is complete, the printer enters the Normal
status.

After the initial adjustment printing, cut the media.
Refer to “
Cutting media on page 91
”
Step 3:
Measure the distance between the two pluses in the initial adjustment print using a
ruler.
Step 4:
Sets up Initial Adjust Change.

Press + or – to select "PF2: Initial Change".

Press
Enter
.

"Init.: 250.0/250 mm" is displayed.

Press + or – and enter the measured value in step 3.

Press
Enter
.

The initial adjustment value is saved.

"PF2: Initial Change" is displayed.
Note

The length of media that is fed for the initial adjustment print is normally set to
250 mm.

If you increase the feeding length, the accuracy of the media feed
compensation improves.
To change the feeding length, press the [+] or [-] key and change the set value.
N° Description
1
Feed length
2
Media feeding direction