MAINTENANCE MANUAL
VCE-MM-02
54
Pre-run the media back and forth using the arrow key will help. (Reload the media and pre-run.)
The edge of the media is not straight. (Change the media.)
Media is too thin. (Change it.)
Drum is coated with paper chips or dust. (Clean the surface of drum.)
Drum or pinch roller is worn. (Change the drum set or pinch roller.)
The lines quality is wavy.
[Causation and recovery:]
Forget to fasten the tool fastening screw. (Fasten it.)
The blade is worn. (Change it.)
The acceleration is too high. (Set the acceleration to a lower value; please refer to the default
value.)
The carriage belt tension is incorrect. (Adjust the belt tension.)
X or Y motor belt tension is incorrect. (Adjust the belt tension.)
The spring loading bearing of carriage is damaged. (Change the carriage set.)
The length of the media is too short in X direction. (Change the media.)
Media is too thin. (Change it.)
Drum or pinch roller is worn. (Change the drum set or pinch roller.)
X or Y motor is damaged. (Change it.)
Data loses when plotting.
[Causation and recovery:]
Memory chip is bad. (Change it.) Main board set is bad. (Change it.)
Fatal error occurs when loading media.
[Causation and recovery:]
Forget to pull out some media from the media roll. (Pull out some media from the roll before you
start to load media.)
X motor belt is too tight. (Adjust the belt tension.)
Feel electrostatic discharge.
[Causation and recovery:]
Power out let does not have ground connection. (Improve it.)
Summary of Contents for ValueCut VC-1300
