9
ENGLISH
LOW LEVEL INPUTS CH5 & CH6 (optional, only M6
v2
):
If you want to use the signal input section with low level signals (e.g. with the pre-amplifier outputs
from your head unit), please refer to page 16.
BATTERY TER/-:
BAT+: Connection terminal for positive (+) power supply from the car specific or ISO cable harness
BAT-: Connection terminal for negative (-) power supply from the car specific or ISO cable harness
These power terminals are paralleled with the POWER terminals internally. The power cables must
be properly insulated to prevent electrical short.
SPEAKER OUTPUTS CH5 & CH6
These speaker outputs are amplified and can be operated bridged (BLT mode). It is recommended
to connect here a passive subwoofer bridged (4 Ohms) or an additional speaker pair (2 - 4 Ohms).
HIGH LEVEL INPUT CH5 & CH6 / REM IN-OUT
This 6 pole connector is suited to manage the high level speaker inputs CH5 & CH6 as well as the
REM IN / REM OUT connections.
The high level speaker inputs CH5 & CH6 can be used for the separate subwoofer outputs from a car
stereo/head unit.
REM OUT is suited to turn on other devices/amplifiers of the sound system, such as additional amplifi-
ers. It takes about 10 seconds to supply the signal to the REM OUT output. The 200 mA output current
capability can also drive an auto-motive relay.
REM IN is suited to turn on the amplifier if a turn-on signal from the head unit/car stereo is available.
The voltage must be between 7.5 and 15 VDC.
1:
3:
2:
4:
1:
4:
2:
5:
3:
6:
SPEAKER OUTPUT 6+
SPEAKER OUTPUT 6-
SPEAKER OUTPUT 5+
SPEAKER OUTPUT 5-
REM IN
REM OUT
HIGH-LEVEL INPUT 5-
HIGH-LEVEL INPUT 5+
HIGH-LEVEL INPUT 6-
HIGH-LEVEL INPUT 6+
3
4
5
This connection is not suited for the direct connection with the vehicle’s battery. If you oper-
ate the amplifier with higher power consumption, for example with bridged speaker output
channels (BLT mode), it is mandatory to use the POWER terminals. Please refer to section
POWER on the previous page for more details.
WARNING
