16
ENGLISH
OPTIONAL LOW LEVEL RCA ADAPTER CABLE SETS
Follow the instructions below to configure the input signal section CH1-6 from high level into low level inputs:
To use the input section CH1-6 with Low Level signals (e.g. with the pre-amplifier outputs from your head unit)
we recommend the optional available MUSWAY Low Level RCA Adapter Cable Sets as described below:
MPK-RCA6-PP*
This two-piece set is suitable for an existing sound system with an M6
V2
DSP amplifier connected via vehicle-
specific ISO cables (MPK-ISO25 or MPK-ISO50). A total of 6 RCA inputs are available for connecting the pre-
amplifier outputs including a remote in- and out cable. The amplified speaker output channels 1 to 4 end in an
ISO connector that must be connected to the speakers which are already wired via the original sound system.
MPK-RCA6*
This two-piece set is suitable for use with the DSP M6V2 amplifier in a standard installation with aftermar-
ket components. A total of 6 RCA inputs are available for connecting the pre-amplifier outputs including a
remote in- and out cable. The amplified speaker output channels 1 to 4 lead to open cable ends to connect
with the appropriate aftermarket speakers.
*NOTE:
For both sets, the wiring of CH5-6 is done as usual via the 4-pin cable connector described on
page 9 (section 4).
1. Remove the bottom plate of the amplifier by unscrewing the four screws.
2. In the marked area on the image below you will find a jumper.
3. Carefully remove this jumper with a suitable gripper.
LOW LEVEL INPUTS CH1- 6 (OPTIONAL)
Only carry out this step af-
ter the device has been dis-
connected from the power
supply.
WARNING
