be used, it must be a minimum 14 ga, 3 wire with grounding type plug and connector and rated not less than 1875 watts.
The extension cord shall not be more than 20 ft (6 m) in length.
WarnInG: Electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the
risk of fire, electrical shock and injury to persons.
WarnInG: Do not use this fireplace insert if any part of it has been under water. Immediately call a qualified service
technician to inspect the firebox and replace any part of the electrical system which has been under water.
sErVIcE InstructIons
For Your safety
Service must be performed by qualified/authorized service personnel only.
Glass Information
1. Under no circumstances should this product be operated with a broken or chipped glass panel.
2. Do not strike or slam the glass.
3. Do not use abrasive cleansers to clean the glass.
4. This product uses tempered glass. Replacement of the glass supplied by the manufacturer should be done by
qualified/authorized service personnel only.
replacing the Light Bulbs
This fireplace insert uses 3 clear 120 Volt, 40 Watt, E-12 socket base light bulbs
(small base, chandelier candle type bulbs). The light bulbs are located at the
bottom of the unit. You can change the light bulbs from the front of the firebox.
For convenience, if one of the light bulbs burns out, it may be easier to replace
all of the light bulbs at the same time.
WarnInG: Do not exceed 40 Watts per bulb. Use of higher rated light bulbs may
cause overheating and result in a fire, causing property damage, personal injury or
loss of life.
1. Turn the firebox power “on/off” switch to the “off” position.
2. Let the firebox insert cool if it has been operating.
3. Remove three screws (from the back) from each support bracket, starting
with the third screw down from the top of trim.
4. Remove the front glass panel from the firebox by gently sliding it forward.
5. Unscrew the 2 rosebud log screws, one on the left side and one on the right
side of the log set, to be able to remove the log rack.
6. Lift and gently remove the log rack to reveal the light bulbs.
7. Unscrew each light bulb and replace with a new one.
8. Reverse steps 3-7 to re-assemble the firebox.
3
Step 7
Step 6
Step 5
Step 4
Step 3
