M1 CLiC issue 5
Page 4 of
24
Installation, precautions and user information
This new M1 CLiC is designed and built to provide trouble-free performance, but as with all electronic devices it is necessary
to observe a few precautions:
• Heed all warnings shown on the back of the product.
• The M1 CLiC has a built-in universal power supply that can be connected to 50-60Hz A.C. mains of between 80 to 253V
rms without modification.
• Always ensure that when disconnecting and reconnecting audio equipment the mains supply is switched off.
• Position the mains lead and signal interconnects where they are not likely to be walked on or trapped by items placed on
them.
• Do not use near water, or place water-filled containers on the M1 CLiC, for example, a flower vase or potted plants.
If
water does spill inside, immediately pull out the mains plug from the wall socket and inform the dealer, who
should then check the unit before further use. Entry of liquid into the M1 CLiC is dangerous, and may cause
electric shock or fire hazard.
• Do not place the unit near direct heat sources such as radiators, direct sunlight or other equipment.
• Do not remove any covers or try to gain access to the inside. There are no user adjustments or fuses to change without
qualification. Refer all service work to an authorised Musical Fidelity agent.
* Note: Unauthorised opening of the equipment will invalidate any warranty claim.
• Dust regularly with a soft cloth or soft brush but be careful when using cleaning or polishing agents - they may harm the
surface finish.
The electronics in modern hi-fi equipment is complex and may, therefore, be adversely affected or damaged by lightning.
For protection of the audio system during electrical storms, remove the mains plugs.
If after-sales service is required, to help the dealer identify the M1 CLiC please quote the serial number located on the rear
panel of the unit.
Important note:
In normal operation, the unit dissipates a small quantity of power at all times, and it is important that it is
adequately ventilated. The M1 CLiC must be protected from humidity – if the unit is moved from a cold place
to a warm room, leave the unit for an hour or so to allow sufficient time for the moisture to evaporate.
Web-based updates
The M1 CLiC has a flexible design that allows updates to be issued from time to time. These updates are downloaded via
the network and into the unit itself directly, whereupon it will either ask to be switched off or reset by itself.
Please note down any important settings, if required, before updating, as all user settings are reset during this
process.
The nature of these updates will not normally affect the sound quality, but functionality to a greater or lesser degree, and
may or may not provide further features that were not originally available.
The only update available is that on the website. We
do not
make or allow any third party custom updates or configurations,
and beware of third parties offering to do so. The ONLY update supported by Musical Fidelity is that which currently resides
on the website.
It is recommended the unit and network is left alone during the update process to ensure timely completion. Update speed
depends on internet speed as well as coinciding network traffic to other computers or devices sharing the same network
router/gateway. Always allow for at least 5 minutes for broadband/ADSL (assuming no other network traffic present) or
longer for slower or busier connections.
Legal Notice
“Made for iPod
®
” or “Made for iPhone
®
” means that an electronic accessory has been designed to connect
specifically to iPod
®
or iPhone
®
respectively and has been certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory
standards. Please note that use of this accessory with iPod
®
or iPhone
®
may affect wireless performance.
General Advice
