M1 CLiC issue 5
Page 19 of
24
Analogue
PRE Output impedance
47 ohms
PRE Output level
0 to 300mV r.m.s nominal.
8V r.m.s maximum.
PRE Output gain on AUX inputs
4.5x (13dB) at maximum volume
Frequency response
10Hz to 20 kHz -0.1dB max.
Channel separation
>105dB 20 Hz to 20 kHz
Signal to noise
>119dB “A”- wtd.
Total harmonic distortion
<0.0025% 10Hz to 20 kHz
Digital
DAC circuit
24 bit Delta-Sigma (bit stream) dual differential 8x over-sampling
to 192 kHz
Total correlated jitter
<12 picoseconds peak to peak
Linearity
<0.1dB down to -96dB
Frequency response
10Hz to 20 kHz -0.1dB max.
Channel separation
>105dB 20 Hz to 20 kHz
Signal to noise
>119dB “A”- wtd.
Total harmonic distortion
<0.0025% 10Hz to 20 kHz
Connections
Line level outputs
1 pair line level RCA (phono), fixed outputs left and right, not controlled by
volume at 0dB (i.e. same as input).
1 pair line level pre-outputs (controlled by volume).
Line level inputs
3 pairs line level inputs AUX1, AUX2, AUX3
Digital inputs
2 RCA coaxial connectors SPDIF 32-192 kbps (16-24 bit stereo PCM)
1 TOSLINK optical connector 32-96 kbps (16-24 bit stereo PCM)
1 Front mounted USB type ‘A’ socket for USB “pen”/hard disk drive
1 Rear mounted USB type ‘A’ socket for iPod
®
or iPhone
®
USB lead.
(Does not support Apple “Dock”)
1 USB type ‘B’ connector for computer/PDA 32-48 kbps
Network inputs
1 RP-SMA plug Wifi Aerial input (“wireless” network connection) 802.11b/g
1 UTP RJ45 10/100Mbps socket (“wired” network connection)
Trigger output
1 3.5mm Jack 12V trigger
N.B. 9-pin D type plug is for factory use only. No features or upgrades available for or from this port.
Power requirement
Mains voltages
80-253VAC 50/60Hz universal
Consumption
25 Watts maximum
Display
Colour LCD QVGA 320x240
Electronic Specifications
