Murray 620000x30C, Owner'S Manual

Page: 18 / 52

TROUBLE SHOOTING CHART
18
F–011013M
TROUBLE CAUSE CORRECTION
Motor runs erratically Damaged motor Have the unit serviced by a
competent repairman.
Obstruction in auger Remove obstruction.
Clean auger housing.
Clean ice and snow from
discharge chute.
Excessive vibration Loose parts Stop motor immediately and
unplug power cord.
Tighten all bolts and make all
necessary repairs. If
vibration continues, have the
unit serviced by a
competent repairman.
Damaged auger Repair or replace auger
assembly.
Unit fails to propel itself Drive belt loose or damaged Replace drive belt.
Worm auger assembly Replace auger assembly.
Unit fails to discharge
snow
Auger drive belt loose or
damaged
Replace if damaged.
Discharge chute clogged Stop motor immediately and
unplug power cord.
Clean discharge chute and
inside of auger housing.
Foreign object lodged in
auger
Stop motor immediately and
unplug power cord.
Remove object from auger.
Motor stops Snow Thrower is overworked The motor is equipped with a
protector that will disconnect
power to the motor
temporarily if the snow
thrower is overworked, and
will automatically reset as the
motor cools. If the motor
stops, release the control
bar, disconnect the extension
cord and allow the motor to
cool 5 minutes before
continuing operation. If this
happens often take your
snow thrower to an
authorized Service Center
for repair and adjustment.