ASSEMBLY
8
F–041306C
3. Insert the
right lower handle
into the
mounting channel
(see Figure 3). Make
sure the flat end at the top of the handle
is facing inward.
4. Mount a
washer
on each
screw
. Push
the
screws
through the
tine shield
, the
lower handle
, and half way through the
engine casting (see Figure 4).
5. Insert the
left lower handle
into the
mounting channel
(see Figure 3). Make
sure the flat end at the top of the handle
is facing inward.
6. Push the
screws
through the engine
casting, the
lower handle
, and the
tine
shield
. Secure with
washers
and
lock-
nuts
as shown in Figure 4. Do not tight-
en as this time.
7. Remove the fasteners from the upper
handle (see Figure 5).
8. Assemble the
upper handle
to the lower
handles with the fasteners.
9. Tighten the
knobs
.
NOTE: To tighten the knobs, hold the
curved carriage bolt head against the
outside of the lower handle as you
tighten the knobs.
10. Tighten the
locknuts
that hold the ends
of the lower handles (see Figure 4).
Tighten only enough to firmly hold the
handles.
CAUTION: Over tightening the lock-
nuts can change the shape of the han-
dle and damage the engine casing.
Figure 3
Left Lower
Handle
Right Lower
Handle
Mounting Channel
Screw
Washer
Washer
Locknut
Tine Shield
Figure 4
Figure 5
Carriage
Bolt
Flat Washer
Curved
Washer
Knob
Upper Handle
Summary of Contents for 11052x4NC
Page 70: ...NOTA 70 F 041306C...
Page 71: ...NOTA 71 F 041306C...
