Murphy HelmView HV750, Operation Manual

Page: 10 / 32

Section 78 00-02-0805
12-09-11
-
8 -
Gauge Display
The Gauge Display screen consists of several predefined layouts that contain combinations of
analog gauges, straight bar gauges, or digital (text) readouts. These screens display upon
startup.
NOTE: On occasion gauges may ‘grey out’; this is caused when the
HV750 is not reading the CAN message properly from the source address
for which it is configured. This mainly occurs if the message is not being
broadcast on the network, or if the settings within the display are not
configured to read the parameter from the correct source.
A GPS screen is included in the HV750. A GPS device must be connected to the HV750 to
provide time and other readings from which to calculate trip and fuel information.
To scroll through the various gauge screens, press the
Previous
and
Next
soft keys. Repeat
this action until all screens have been viewed. The currently displayed screen stays active until
another key is pressed. To review all screens available without accessing the HV750, see the
Gauge Screens
section at the end of this document. The following section gives more
information on using the Soft Key Commands.
Soft Key Commands
When a Gauge Display screen is active, pressing the
Enter
key displays other soft key
commands. Continue to press
Enter
to toggle through additional soft key commands, and
eventually remove the soft key icons from the screen.