CE-05171N page 31 of 44
6
6..3
3..1
12
2 IIn
niittiia
all R
RP
PM
M S
Se
ettu
up
p
a
a)) Assign value for Warmup RPM.
b
b)) Assign value for Wait to Load RPM.
c
c)) Assign value for Run Loaded RPM.
d
d)) Assign value for Cooldown RPM.
6
6..3
3..1
13
3 M
Miis
sc
ce
elllla
an
ne
eo
ou
us
s S
Se
ettu
up
p
User can access and edit the miscellaneous settings.
a
a)) Crank Attempts: Define a value for number of crank
attempts after which an over-crank sequence will be trig-
gered in the Event logic.
b
b)) Controller Slave Address: Provide the value for the Modbus
Address Port. The factory default is 1.
c
c)) Port 1 Mode: Select Communication Port 1 as RS232, or RS485.
d
d)) Port 1 Reply Delay: To ensure sufficient time for the
Modbus reply, assign appropriate time value for Delay
Modbus Reply Port 1.
e
e)) Port 1 Baud Rate: Select appropriate transmission baud rate
ff)) Port 2 Mode: Select Communication Port 2 as RS232, or RS485.
g
g)) Port 2 Reply Delay: To ensure sufficient time for the
Modbus reply, assign appropriate time value for Delay
Modbus Reply Port 2.
h
h)) Port 2 Baud Rate: Select appropriate transmission baud rate
ii)) Flywheel Teeth: Define a value for Flywheel Teeth used to
calculate RPM.
The following cold temperature offset values should only be adjusted by personnel with a full working knowledge of the
Centurion in conjunction with calibrated reference equipment.
jj)) Core Cold Temp Offset: Enter a non-zero Value for Core
Temperature Adjustment (in tenths) to adjust the temperature
readings for all Thermocouple inputs on both the Main I/O Module
(C3-1). Entering a non-zero value will adjust the Cold Junction
Compensation reading used to calculate temperature.
k
k)) Exp Cold Temp Offset: Enter a non-zero Value for
Expansion Board Temperature Adjustment (in tenths) to
adjust the temperature readings for all Thermocouple inputs
on Expansion I/O (C3-2). Entering a non-zero value will
adjust the Cold Junction Compensation reading used to cal-
culate temperature.
ll)) Hour Meter: The user may make hour meter adjustments.
The range is 0 – 65535 hours.
TM
C
C
C
Initial RPM Setup Screen
___________________________________
▼
▼
INITIAL RPM SETUP
WARMUP RPM
00600
WAIT FOR LOAD RPM
RUN LOADED RPM
COOLDOWN RPM
▼▲
ENTER-EDIT
MORE MENUS
___________________________________
___________________________________
▼
▼
TM
C
C
C
Miscellaneous Setup Screen
___________________________________
▼
▼
MISCELLANEOUS SETUP
NUMBER OF CRANK ATTEMPTS
00003
PORT 1 SLAVE ADDRESS
PORT 1 RS432/RS485
PORT 1 RESPONSE DELAY
PORT 1 BAUD RATE
▼▲
ENTER-EDIT
MORE MENUS
___________________________________
___________________________________
▼
▼
