Page 8 of 13
CONTEMPORARY WATER COOLERS
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
7109-700-001
WATER COOLERS
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
Please visit
www.murdockmfg.com
for most current specifications.
ELECTRICAL INSTALLATION:
NOTE: PLUG IN OR BATTERY POWER IS A STANDARD FEATURE.
1A. Plug-In Operation: Plug transformer provided into GFCI protected electrical service, used by the drinking fountain.
thread transformer wire through hole in deck and connect to red sensor wire. For Bi-Level wire may pass through
drain connection opening.
1B. Battery Operation: Peel off paper backing from hook & loop pads then press battery holder firmly in place.
(See page 4). Connect the battery holder wires to the red sensor wires. Unit requires six AA, alkaline or lithium
batteries (not included). Note: When the battery holder is connected, the unit active.
2. Connect the blue sensor wires to the solenoid valve wires.(See Page 4)
START UP:
1. Air within the bottle filler system or the structure supply pipping will cause an irregular spout outlet stream until
purged out by incoming water. Hold cup (or similar object) directly below filler spout is recommended when first
activating bottle filler to prevent excessive splashing. Active sensor until steady water stream is achieved.
2. Using the same method, hold cup (or similar object directly over bubbler(s) and active bubblers until air purged out
and a steady stream is achieved.
OPERATING INSTRUCTIONS:
Hold container to be filled just below the sensor in the center of the unit,
then move the container upward, (make sure the container is centered
under the fill spout) water flow starts automatically. When the
container is almost filled, lower the container below the sensor until the
water stops flowing. (see label on the Bottle Filler)
MCBF2 (Install/Maintenance Instructions)
Date:
04/03/18
Fill Spout
Bottle Filler
Label
Sensor
