9
© Munters Corporation, August 2018
QM1190r7
Figure 8B
Guard Mounting
Pad
Guard
eyelet
Installation Instructions
Chapter 2
Figure 7B
Cone
Guard
Guard Tab
Guard Tab
Guard Slot in cone
Figure 8A
Nut
Bolt
Guard Mounting Pad
Guard
Fan Outlet
Step 9
If installing your existing guard into the new cone, locate the flat guard mounting pads on the cone and drill
a
9
⁄
32
” dia. hole in the center of each pad. Then insert existing guard into cone with the guard eyelets facing
away from you. Line up each eyelet with a hole in the guard pads. Secure guard to cone using (8) existing
Bolts and Nuts.
See Figure 8A and 8B.
Tighten all nuts at this time.
Step 8
Starting at the bottom of the cone, locate one of the guard tabs and put the guard tab through the guard slot
in the cone.
See Figure 7B.
Then work up around the guard and install each of the other guard tabs in each
of the corresponding guard slots. Some force may be required to snap the last tab into the last slot, pull out
on the center of the cone while pushing in on the guard tab until it snaps into place.
