© Munters Corporation, August 2018
16
QM1190r7
Figure 13D
On/Off Remotely
Control
Relay
Junction Box
(By Others)
Munters Drive Box
‘RUN’ Switch
Electrical Wiring
Chapter 3
Munters Drive Box
Circuit Board in Munters Drive Box
To operate the Munters Drive On/Off with a control, Slide the ‘RUN’ switch, located on the circuit board in
the Munters Drive Box, to the ‘OFF’ position. Now wire an ‘ON’ command from the ‘COMMON’ terminal
to the input relay in the control and from the output of the control relay to the ‘RUN’ terminal in the Munters
Drive Box.
See Figure 13A & 13D.
Jumpers
***WARNING***
The Blue Box electrical enclosure must not be
removed from mounting bracket. Removing
Blue Box from the mounting bracket will void the
warranty. Any water or other damage to the
controller will not be covered if the Blue Box is
removed.
***NOTE***
All Low Voltage wire must be shielded
cable. i.e. Belden 8770 or equivalent.
