2
Don't install the air conditioner in the following locations:
2. INSTALLATION INFORMATION
INSTALLATION ORDER
Select the location;
Install the indoor unit;
Install the outdoor unit;
Install the connecting pipes;
Connect the drain pipe;
Wiring;
Test operation.
CAUTION
Keep the interconnection cable away from the copper
tube.
After completing the installation work, check if the
refrigerant does not leak.
Toxic gas may be produced if the refrigerant leaks into a
room and comes into contact with a source of fire, such as a
fan heater, stove or oven.
This appliance is not intended to be used by people
(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instructions concerning the
use of the appliance by a person responsible for their safety.
Disconnect the power supply before cleaning and
maintenance.
Ground the air conditioner.
Do not connect the ground wire to gas or water pipes,
lightning rod or a telephone ground wire.Incomplete
grounding may result in electric shocks.
Check
the
power
supply.
Check
the
power
supply
before
installation.
Ensure
that
the
power
supply
must
be
reliably
grounded
following
local,
national
and European
Electrical
Codes.
If
the
ground
wire is detected
while charged, installation
is
prohibited
before
the wire
is
repaired. Otherwise,
there
is a
risk
of
fire
and
electric
shock,
causing
physical
injury
or
death.
Check
the
layout.
Check
the
electric
wire,
water
and
gas
pipeline
layout
inside
the
wall,
floor
and
ceiling
before
installation.
Do
not
drill unless
safety is confirmed
together with
the
user,
especially
for
hidden
power wires.
A mains test
can
be
used
to
check
whether
a passing
wire is at
the
drilling
location,
to
prevent
physical
injury
or
death
caused by
insulation
broken
cords.
Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in
electric shocks.
Connect the outdoor unit wires , then connect the indoor
unit wires.
You are not allow to connect the air conditioner with the
power source until wiring and piping is done.
While following the instructions in this installation
manual, install drain piping in order to ensure proper
drainage and insulate piping in order to prevent
condensation.
Improper drain piping may result in water leakage and
property damage.
Install the indoor and outdoor units, power supply wiring
and connecting wires at least 1 meter away from
televisions or
radios in order to prevent image
interference or noise.
Depending on the radio waves, a distance of 1 meter may not
be enough to eliminate the noise.
The appliance is not intended to be used by young children
or by people with disabilities without supervision.
DISPOSAL
：
Do not dispose of this product as unsorted
municipal waste. Waste must be collected separately for
necessary special treatment.
If there is petrolatum nearby.
If there is salty air surrounding it (near the coast).
If there is caustic gas (such as sulfide, for example)
present in the air (near a hot spring).
If there is high voltage variation (within factories).
In buses or closed cabinets.
If there is oil gas inside a kitchen.
I strong electromagnetic waves are present.
Around inflammable materials or gas.
If there is acid or alkaline liquid evaporating.
Around other special conditions.
To perform the installation properly, please read this
"installation manual" first.
The air conditioner must be installed by qualified personnel.
When installing the indoor unit or its pipes, please follow this
manual as strictly as possible.
If the air conditioner is installed on a metal part of the
building, it must be electrically insulated according to the
relevant standards on electrical appliances.
When all the installation work is finished, please turn on the
power only after a thorough check.
This manual can be changed without further announcement if
there is any change of this manual caused by product
improvement.
