9
Mounting the EOS-110
1. Disconnect the voltmeter or tester.
2. Use the two self-tapping machine screws supplied to mount EOS-110.
3. Plug vehicle wire harness into EOS-110.
4. There is a piece of heat shrink tubing supplied with the EOS-110 which can
be shrunk over the connector when installation is finished. This is to seal
and deter tampering with the connector.
Optional Cover
The EOS-110 can be supplied with an optional cover (074-20019) which will seal
the bottom of the EOS-110. To install this cover:
1. Remove the existing foam seal from the bottom of the EOS-110.
2. Using the 6 screws from the kit, screw the plate into place so that the
seal/gasket is facing in.
Field Replacement of the EOS-100
The EOS-110 can be used to replace the EOS-100.
Using the new wiring harness provided either make a new connection as shown
in the wiring instructions of this booklet or splice the new harness into the old by
matching wire colors. Make sure there is a fuse in the red wire circuit.
EOS-110 SPECIFICATIONS
Input Voltage ..........................................
+
9-18 VDC
Operating Current .................................. 20 ma
+
(Output Load)
Signal Input (Alternator) ......................... 12 Vac P-P min.
Input Frequency Range ......................... 50-1800 Hz
Output Load ...........................................
+
9-18 VDC @ 5 Amp Inductive
Load Fused to 10 Amp
Operating Temp Range ..........................
–
20°C To
+
100°C
Linearity ..................................................
±
5%
Weight .................................................... 1 Lb.
EOS-111 Input Frequency Range .......... 50-3000 Hz