RPR 950 Series
9261 – 9558 Issue 1
20
Insert a thin blade or fingernail under the edge of the back-
plate as indicated by the arrow and lift away from the pager
body. Once the plate is clear, gently slide the clip towards the
bottom of the pager, until it comes away from the main body.
Before attempting clip replacement, ensure that the grip
adjustment slider is set to the top of the clip and that the metal
back-plate has been straightened. Re-insert the metal clip-
back into the guides on the case-back and slowly slide the clip
assembly into place, ensuring that the retaining lug re-locates
into the slot in the case-back.
16. ABSENCE & CHARGING
When your pager is inserted into an Absence Rack, it will
automatically be switched into the
absence mode
. A pager
that is already on will reset and a pager that is
off
will switch
on
and enter the
absence mode
.
NB: No paging calls will be accepted whilst the pager is in
the rack and any stored messages will be erased.
When in a rack, your pager may display a programmable
message of up to 9 characters. Unless programmed
otherwise, the default message will be your pager's RIC
(receiver identity code) number. This message may be
programmed either prior to bringing the pager into service, or
new alphanumeric messages may be transmitted to it via the
absence rack data bus.
