RPR 950 Series
9261 – 9558 Issue 1
15
12. TIME OF DAY
Your pager may be programmed to show the time of day,
when in quiescent mode. The actual source of the time signal
may be from the pager's own internal clock, or an off-air signal
from your controlling system, where available. The time data is
used to ‘time-stamp’ incoming messages.
Off-air time signal
- If this option has been selected, your
pager display will show the symbol
--:-- in the quiescent state,
until the first valid time signal (transmitted every minute) has
been received from the system. If the pager should go out of
range of the system and no time signal is received for 2
minutes, then this symbol will also be displayed until a valid
signal is again received.
Internal Clock
- where the off-air time signal option is not
enabled, it is possible to activate and set the pager's internal
clock. To set the time, press the OCR button during the
switch-on sequence and the time-of-day screen will initially
show the hours flashing.
To change the hours repeatedly press, or press and hold the
OCR button, until the desired hour is displayed. When this
point has been reached, press the MUTE button and the
minutes will start to flash. Press the OCR button until the
desired minutes are displayed. To complete the set-up, press
the MUTE button and the pager will continue the switch-on
sequence.
To reset the time on a pager which has already been
switched-on, or time incorrectly entered, simply turn the pager
off and on again and follow the set-up sequence.
