RP-600
DUAL BAND PMR 446 / LPD 433 UHF FM VOICE PAGER
OPERATING MANUAL
INTRODUCTION
This product has been specifically designed for the following purposes :
-
as a Voice Pager in Tourists Guided Tours
-
as a Voice Pager in Conferences, Meetings, etc.
-
as a Voice Pager in traditional Paging Systems (in stores, hotels, restaurants, resorts, factories, warehouses, offices, shops,
etc.) and wherever a same message from a main transmitter must be received by either one or more groups of persons or by
a single person.
The pager operates in the PMR-446 (8 channels) and LPD-433 (69 channels) UHF FM bands. 38 CTCSS codes, call vibration
alert, earset or built-in speaker and more features are included. Band, channel and all other functions are fully programmable by
the system manager in the PROGRAM mode. Please read the following operating instructions before using the radio.
\
BATTERY CHARGING / 230VAC WALL ADAPTOR CHARGER (Mod. AC-600)
When the battery capacity is low, the Battery Level Indicator (G) blinks. Recharge batteries at this time. When the battery capacity
is low, switch OFF the pager and connect the wall charger to the CHARGE jack (1), then plug it to a 230VAC outlet ; the Battery
Level Indicator bars (G) will blink indicating that the wall charger is connected to the pager and that the charging process is
running. To obtain the maximum performance from the batteries, recharge them only when they are fully discharged. The
approximate charging time with 2 x 1500 mAh Ni-MH batteries is 8-12 hours, depending on the batteries condition.
When the
charging time has expired, unplug the wall charger from the AC outlet and then disconnect it from the pager.
BATTERY CHARGING / MULTIPLE DESK CHARGER (Mod. MDC-600)
Please refer to the instruction manual supplied with the Multiple Desk Charger.
WARNING !
1.
If the product will not be used for a long period of time, please take out the batteries.
2.
Please dispose of old or defective batteries in a safe and environmentally friendly manner.
3.
Do not dispose of batteries in fire.
4.
Do not recharge batteries for more than 12 hours, to avoid overcharge or overheating, which could damage the radio.
5.
Do never try to recharge alkaline batteries, as this might cause damage to the radio or explosion of the batteries.
6.
Do not use chargers or accessories others than the original ones, otherwise damage to the radio may occur.
KEYS AND CONTROLS
1.
Earset / Charge Jack
2.
Holes for Necklace
3.
UP Key
4.
DOWN Key
5.
Built-in Speaker
6.
Desk Charger Contacts
7.
MENU / Monitor Key
8.
ON-OFF Key
9.
Backlighted LCD
LCD DISPLAY
A.
Channel Number or
Volume Level
B.
CTCSS Code Number
C.
BUSY Icon
D.
Vibrator Alert Icon
E.
Keypad Lock Icon
F.
CALL Alarm Icon
G.
Battery Level Indicator
BATTERY INSTALLATION
1.
Remove the locking screw (12).
2.
Remove the Belt Clip (10)
3.
Slide down and remove the
battery door (11).
4.
Install 2 x AA size batteries.
Please respect correct polarity.
5.
Re-install the battery door (11).
6.
Re-install the Belt Clip (10)
7.
Re-install the locking screw (12).
