RPR 750IS Series
9261-7912 Issue 8
17
*Low
battery
Battery
voltage
is
low.
*Time of Day
Dependent upon your pager
options, see Section 12.
*Mute Pager
in
Mute
mode.
*Vibrate
Vibrate
option
selected.
On
No other messages to
display.
*Note:
Your pager has to be programmed for this option, to
display this message.
12. TIME OF DAY
Your pager may be programmed to show the time of day,
when in quiescent mode. The actual source of the time signal
may be from the pager's own internal clock, or an off-air signal
from your controlling system, where available. The time data is
used to ‘time-stamp’ incoming messages.
Off-air time signal
- If this option has been selected, your
pager display will show the symbol
--:-- in the quiescent state,
until the first valid time signal (transmitted every minute) has
been received from the system. If the pager should go out of
range of the system and no time signal is received for 2
minutes, then this symbol will also be displayed until a valid
signal is again received.
Internal Clock
- where the off-air time signal option is not
enabled, it is possible to activate and set the pager's internal
clock. To set the time, press the OCR button during the
switch-on sequence and the time-of-day screen will initially
show the hours flashing.
To change the hours repeatedly press, or press and hold the
OCR button, until the desired hour is displayed.
