RPR 750IS Series
9261 - 7912 Issue 8
16
Once programmed, this option may be switched on or off by
using the MUTE button and stepping through the mute/vibrate
option sequence.
The
Silent Alert
configuration may be changed, by pressing
and holding the MUTE button for 1.5 seconds, whilst the pager
is in the quiescent state. The current mode will be displayed
and each further press/hold of the MUTE button will cause the
pager to cycle through each option, until the desired mode is
obtained. Each change is acknowledged by an audible pip
and where applicable, short vibration. Pressing the OCR
button in the quiescent state, will allow you to check the
selected option status.
The available options are: -
On
- normal audible alert, no vibrate;
On + vibrate
- as for On, with vibrate enabled.
Mute + vibrate
- alert tones and speech muted, with vibrate
enabled.
11. PAGER STATUS
Your pager is equipped to provide status information on-
demand. To activate this feature, whilst the pager is in
quiescent mode, press the OCR button once. This will cause
the message
status >
to be displayed, automatically followed
by each programmable status message, as follows: -
Status
Message Condition
1 New message
Message(s) with new status exist.
2 New messages
*Out-of-range
Your pager has not received
a valid system signal for 3.5
minutes min.
