5
iv) Enter SETUP/General Settings/Send a message to the apartment door. Tap
icon (Figure 3)
“Message is sent” alert will be seen on the screen. This means that, message is sent to DIP-01 device which is on
programming mode
Figure 5. Monitor SETUP page
Figure 6.
Tap “ Send a message to the apartment door”
v) Internal door room panel is reset, the button starts flashing with light blue color in about
three minutes. When the device is ready to be used, the button color changes to blue. If the
button is tapped, the related room monitor rings.
Using these steps, DIP-01 and the room monitor become matched with each other. When the call
button on DIP-01 is tapped, the matched monitor rings and the screen shows the camera of the
monitor.
4) USING DIP-01 AS FLAT / VILLA INDOOR PANEL :
a) Calling the monitor by touching the button of DIP-01 :
DIP-01 has a touchmatic button with a blue color. When the button is touched the color of the
button turns to yellow momentarily.
When the button of DIP-01 is touched the matched monitor starts ringing and the monitor screen
shows the camera of the panel. By touching
icon on the monitor the conversation starts.
