21
Configuring the MultiVOIP
Consecutive Packets Lost
defines the number of
consecutive packets that are lost after which the call is
automatically disconnected. The default setting is
30
.
Call Duration
defines the maximum length of time (in
seconds) that a call remains connected before the call is
automatically disconnected. The default setting is
180
seconds. A call limit of three minutes may be too short for
most configurations. Therefore, you may want to increase
this default value.
22. You can set billing options for inbound and/or outbound
calls by checking them in the
Billing Options
group and
then entering the charge in cents per number of seconds.
23. A minimum and maximum set of values can be set for
Dynamic Jitter Buffer
. When receiving voice packets
from a remote MultiVOIP, it is possible to experience
varying delays between packets due to traffic conditions
on the network. This is called Jitter. To compensate for this
effect, the MVP110 uses a Dynamic Jitter Buffer. The Jitter
Buffer allows the MVP110 to wait for delayed voice
packets by automatically adjusting the length of the Jitter
Buffer between configurable minimum and maximum
values. An
Optimization Factor
adjustment controls how
quickly the length of the Jitter Buffer is increased when
jitter increases on the network. The length of the jitter
buffer directly effects the voice delay between MultiVOIP
gateways.
The Minimum Jitter Value default setting is
150
milliseconds, the Maximum Jitter Value default setting is
300
milliseconds, and the Optimization Factor default
setting is
7
.
Summary of Contents for MultiVOIP MVP110
Page 50: ...82050950...
