Multitech MultiModemISDN MTA128ST-USB, User Manual

Page: 78 / 98

78
MTA128ST-USB User Guide
MTA128ST-USB
Appendix B: Configuration Profiles
Quick Setup Factory Profiles
For quick setup, the MTA128ST-USB includes six Quick Setup Factory Profiles, each of
which is configured for a specific type of port operation. You can load a Quick Setup
Factory Profile into active memory by using the command &Fn, in which n is the number
of the profile you wish to load. If you wish, you can then customize the profile and store it,
using the &W command, so that it loads automatically when the MTA128ST-USB is
turned on or reset. These profiles are stored in permanent memory and are not user-
configurable as such.
&F0 Profile 0—Modem-like operation (default)
&F1 Profile 1—V.110 async operation
&F2 Profile 2—V.120 async operation
&F3 Profile 3—X.75 async operation
&F4 Profile 4—ML-PPP async operation
Quick Setup Example
The following procedure assumes that you want to load, modify, and store Quick Setup
Factory Profile 2 as your default configuration.
1. Select the profile closest to the requirements of your application, in this case— Quick
Setup Factory Profile 2.
2. In terminal mode, type AT&F2 and press ENTER. Quick Setup Profile 2 loads into
the MTA128ST-USB’s active memory.
3. Enter any additional AT commands that you need to customize the selected profile to
your application (see Chapter 4, AT Commands, S-Registers, and Result Codes).
4. Type AT&W0 and press ENTER to save your customized port configuration.
5. Your customized profile now loads automatically whenever the MTA128ST-USB is
turned on or reset.