USING THE WIZARD TO CONFIGURE YOUR DEVICE
MultiConnect
®
rCell 100 MTR-LTE User Guide
29
If you select
PPP-IP Passthrough
mode, the following options are displayed:
a.
In the
Protocol Support
field, choose the internet protocol from the drop down menu (select from
IPv4
and
IPv6
).
b.
In the
IPv4/IPv6 Address
field, type the router's IP address.
c.
For
IPv6
, in the
Prefix Length
field, the length of the prefix displays. Users cannot change this field.
For
IPv4
, in the
Mask
field, type the mask for the network. The default is 255.255.255.0.
d.
In the
IPv6/IPv4 Primary DNS
field, type the address of the primary DNS (optional).
Note:
This is an optional value that can be used if you use a DNS server other than the servers
received from your carrier.
e.
Click
Next
. Or if you are done making changes, click
Finish
.
If you select
Network Router
or
Serial Modem
mode, the following options are displayed:
a.
In the
IP Address
field, type the router's IP address.
b.
In the
Mask
field, type the mask for the network. The default is 255.255.255.0.
c.
This field is only available in
Network Router
mode. If you select
Serial Modem
mode, skip this step.
In the
IPv4 Primary DNS
field, type the address of the primary DNS (optional).
Note:
This is an optional value that can be used if you use a DNS server other than the servers
received from your carrier.
d.
Click
Next
. Or if you are done making changes, click
Finish
.
5.
This section is only available if you select
Network Router
or
PPP-IP Passthrough
mode. If you select
Serial Modem
mode, skip this step. In the
PPP Configuration
page, configure PPP for your router.
a.
To use PPP, check
Enabled
. When enabled, your device functions as a router.
b.
For devices that use two antennas,
Diversity
is enabled by default. Diversity enables the use of two
cellular antennas for better performance. ( See
Installing the Router
for more details).
c.
To enable the dial-on-demand feature, check
Dial-on-Demand
. This indicates to the router to bring
up the PPP connection when there is outgoing IP traffic, and take down the PPP connection after a
given idle timeout.
d.
In the
APN
field, type the APN (Access Point Name). The APN is assigned by your wireless service
provider.
e.
Click
Next
. Or if you are done making changes, click
Finish
.
6.
This section is only available if you select
Network Router
or
PPP-IP Passthrough
mode. If you select
Serial Modem
mode, skip this step. In the PPP Authentication page:
a.
From
Type
, select the authentication protocol type used to negotiate with the remote peer:
PAP,
CHAP, or PAP-CHAP
. The default value is
NONE
.
b.
In the
Username
field, type the username with which the remote peer authenticates. You can leave
this field blank, if desired. Username is limited to 60 characters.
c.
In the
Password
field, type the password with which the remote peer authenticates. You can leave
this field blank, if desired. Password is limited to 60 characters.
7.
This section is only available if you select
Serial Modem
mode. For any other mode, skip this step. In the
Serial Port Configuration
page:
