LABELING REQUIREMENTS
Labeling Continuity and Changes
The labeling content and format requirements in effect when a product was approved shall be effective for the life
of the product. The labeling content and format requirements in effect at approval shall also continue to be
effective for modified products. However, the responsible party shall have the option of conforming a product's
labeling to current content and format requirements at any time.
Other Label Requirements
Place the label in one of the following locations so it can be found after installation:
■
On an outside surface
■
Inside a readily available access door or panel
■
On another readily accessible surface
For example, do not put the label on the rear of a permanently wall-mounted device where it is not readily
accessible.
Canadian Labeling Requirements (for Dial-Up Modems)
Requirements estabilished under section 69.3 of the Telecommunications Act for purposes of section 5 of the
Telecommunications Apparatus Regulations.
Registered equipment shall bear the following identifying marks, and the Declaring Party shall ensure that these
marks are permanently affixed to the equipment:
a.
The registration number — Specifications of this mark are given in the document: Self-Marking of the
Certification/Registration Number on Terminal Equipment — Application Procedure and Agreement;
and
b.
The model identification number under which the product was registered.
A statement of compliance with Industry Canada requirements, such as the one given below, shall accompany each
unit of equipment whether registered under this procedure or previously certified:
This product meets the applicable Industry Canada technical specifications.
For terminal equipment intended for connection to loop-start or ground-start interfaces, the Ringer Equivalence
Number (REN) must be calculated as per Section 1.8 of CS-03, Part I. A REN higher than that determined may be
assigned by manufacturers to allow for production variations. The REN must be marked on the terminal equipment
itself or added to the note below. A note similar to the following shall accompany each unit of equipment whether
registered under this procedure or previously certified:
The Ringer Equivalence Number is an indication of the maximum number of devices allowed to be connected
to a telephone interface. The termination on an interface may consist of any combination of devices subject
only to the requirement that the sum of the RENs of all the devices does not exceed five.
Pursuant to section 69.3 of the Telecommunications Act, certified or self-declared TE will bear a valid identifying
certification number or registration number. The marking of the certification or registration number on the
product shall be as follows:
a.
TAC holder/DP will be responsible for permanently affixing the certification/registration number on the
TE. The certification/registration number (see example below) identifies Certified or self-declared TE to
the public, representatives of the telecommunications common carriers, the Department, and other
MultiModem
®
USB MTMC8-USB/MTMC16-USB User Guide
21
