Chapter 3 – Using the Web Management Software
38
Multi-Tech Systems, Inc. MultiModem rCell User Guide
3.
On the
Packet Filters > DNAT Configuration
screen, define the DNAT rule.
Allow Access –
Select the original target network/host of the IP packets that you now want rerouted. The
original target network/host is the one previously defined in the Network Configuration section.
Example:
Any
External Service –
Select the External Service that you want allowed. The service must be defined in the
Service Configuration section.
LAN IP –
Select the LAN IP to which the packets are to be diverted. Only one host can be defined as the
destination.
Internal Service –
Select the Internal Service to be the destination.
Pre DNAT Service –
Select the service for the Pre-DNAT destination. This service was just defined in the
Service Configuration section.
Example:
MeterPort
Post DNAT IP –
Select the destination to which the IP packets are to be diverted. Only one host can be
defined as the Post DNAT destination.
Example:
MeterIP
Post DNAT Service –
Select the service for the Post DNAT configuration.
Example:
MeterPort
Internal Source –
Select the source address for packets that are going to be sent. If you do not want to
change the address, select
NOCHANGE
.
Example:
NOCHANGE
4.
Save –
Click the
Save
button to save this configuration.
Note:
You must click
Save and Restart
once you have completed and submitted all the screens on
which you have made changes. The device will save all the settings and reboot the PC.
Summary of Contents for MTCBA-EV1-EN3-N3
Page 1: ...MultiModem rCell Intelligent Wireless Router User Guide ...
Page 18: ......
