49
Chapter 4 - Remote Configuration
Changing the Remote Escape Character
To increase security, you can change a remote modems remote configuration escape character. The
remote configuration escape character is stored in register
S9
. The factory default is 37, which is the
ASCII code for the percent character (%). Setting
S9
to 0 (zero) disables remote configuration
entirelybut if you do this remotely, you wont be able to change it back remotely!
1. Establish a remote configuration link with the remote modem as described in Basic Procedure.
2. Type
ATS9=
n
, where
n
is the ASCII code for the new remote configuration escape character, then
press ENTER.
3. Save the new value by typing
AT&W
and pressing ENTER.
4. Type
ATO<CR>
to exit remote configuration.
Summary of Contents for MT5634MU
