Multitech MT5634MU, User Manual, Page: 34 / 80

34
MultiMobile USB User Guide
ANSWER code.
^ Disable data calling tone transmission.
$ Detect AT&T call card “bong” tone. The character should follow the phone number and pre-
cede the user’s call card number: ATDT1028807637853500$123456789
Command: DS= y Dial Stored Telephone Number
Values: n = 0–1
Default: none
Description: Dial a number previously stored in directory number y by the &Zy=x command.
Example: ATDS=1
Command: E n Echo Command Mode Characters
Values: n = 0 or 1
Default: 1
Description: E0 Do not echo keyboard input to the terminal.
E1 Do echo keyboard input to the terminal.
Command: F n Echo Online Data Characters
Values: n = 1
Default: 1
Description: F0 Enable online data character echo. (Not supported.)
F1 Disable online data character echo (included for backward compatibility with some software).
Command: H n Hook Control
Values: n = 0 or 1
Default: 0
Description: H0 Go on-hook (hang up).
H1 Go off-hook (make the phone line busy).
Command: I n Information Request
Values: n = 0–5, 9, 11
Default: None
Description: I0 Display default speed and controller firmware version.
I1 Calculate and display ROM checksum (e.g., 12AB ).
I2 Check ROM and verify the checksum, displaying OK or ERROR .
I3 Display default speed and controller firmware version.
I4 Display firmware version for data pump (e.g., 94 ).
I5 Display the board ID: software version, hardware version, and country ID
I9 Display the country code (e.g., NA Ver. 1 ).
I11 Display diagnostic information for the last modem connection, such as DSP and firmware ver-
sion, link type, line speed, serial speed, type of error correction/data compression, number of
past retrains, etc.
Command: M n Monitor Speaker Mode
Values: n = 0, 1, 2, or 3
Default: 1
Description: M0 Speaker always off.
M1 Speaker on until carrier signal detected.
M2 Speaker always on when modem is off-hook.
M3 Speaker on until carrier is detected, except while dialing.