SETTING UP AND CONFIGURING THE DEVICE
26
Conduit
®
300 Series IoT Programmable Gateway MTCDT3AC-L4G1/-EN Hardware Guide
DIN Rail Installation
The location to mount the DIN rail bracket is on the back panel of the device labeled
DIN RAIL BRACKET
.
You need:
Phillips screwdriver
Bracket Screws (3)
DIN rail mounting bracket
DIN rail (user-provided)
To install the device on a DIN rail:
1.
If connected, disconnect power and all other cables from the device.
2.
On the back panel of the device, locate the screw holes labeled
DIN RAIL BRACKET
.
3.
Mount the DIN bracket on the back of the device using the bracket screws. When facing the back panel
with the device laying horizontally: a) For horizontal DIN rail installation, use the screw holes in the
horizontal row, or b) For vertical installation, use the vertical row.
4.
Secure the device bracket onto the DIN rail by hooking the top of clip first, pressing down, and fastening
the bottom end. The bracket should click or snap into place when properly secured.
5.
Reconnect power, other cables, and all antennas to the device.
