SETTING UP HARDWARE
18
Conduit
®
AP MTCAP2-LNA3-915-042x-POE and MTCAP2-915-042x-POE User Guide
Chapter 5 – Setting Up Hardware
Installing a SIM Card
Models with cellular capability have a micro SIM slot, you'll need a micro (3FF) SIM card from your network
provider.
Note:
-LNA3 models work on both Verizon and AT&T networks. The device detects the carrier based on
your SIM card.
To install the SIM card:
With the contact side facing down, align the notched edge as shown on the following image and slide the
SIM card completely into the SIM holder.
Removing a SIM Card
To remove the SIM card, push the SIM card in. The device ejects the SIM card.
Attaching the Antenna
To connect the antenna:
Finger-tighten the antenna to the SMA antenna connector on your device.
Cabling the Device
To cable the device:
Note:
If using PoE to power your device, refer to
for additional information and skip
Step 2.
1.
Connect the Ethernet cable to the Ethernet port on the device.
2.
Connect the power supply to the MTCAP's power jack and plug it into an electrical outlet.
When the operating system is fully loaded, the STATUS LED blinks.
Summary of Contents for 92507603LF
Page 1: ...Conduit AP MTCAP2 LNA3 915 042x POE and MTCAP2 915 042x POE User Guide ...
Page 22: ...MOUNTING THE DEVICE 22 Conduit AP MTCAP2 LNA3 915 042x POE and MTCAP2 915 042x POE User Guide ...
Page 23: ...MOUNTING THE DEVICE Conduit AP MTCAP2 LNA3 915 042x POE and MTCAP2 915 042x POE User Guide 23 ...
