![background image](http://html1.mh-extra.com/html/multiquip/wsc55/wsc55_operation-and-parts-manual_1855132013.webp)
WSC55 SERIES CHEMICAL SPRAY CART • OPERATION AND PARTS MANUAL — REV. #1 (08/30/19) — PAGE 13
SAFETY INFORMATION
TOWING SAFETY
CAUTION
DO NOT
tow the spray cart on public roads. The tow
hitch is for
on-site towing only
.
Recommended off-road towing is not to exceed
15 MPH
or less, depending on the type of terrain.
DO NOT
tow the spray cart with defective hitches,
couplings, chains, etc.
ALWAYS
inspect the hitch and
coupling for wear.
Avoid sudden starts and stops, which can cause
skidding or jackknifi ng
. Smooth, gradual starts and
stops will improve towing.
Avoid sharp turns to prevent rolling.
Disconnect and stow hoses while towing.
ENVIRONMENTAL SAFETY/DECOMMISSIONING
NOTICE
Decommissioning is a controlled process used to safely
retire a piece of equipment that is no longer serviceable.
If the equipment poses an unacceptable and unrepairable
safety risk due to wear or damage, or is no longer cost
effective to maintain (beyond life-cycle reliability), and is
to be decommissioned (demolition and dismantlement),
follow the guidelines below.
NEVER
pour waste or oil directly onto the ground, down
a drain, or into any water source.
Contact your country's Department of
Public Works or the recycling agency in
your area and arrange for proper disposal
of any electrical components, waste, or oil
associated with this equipment.
When the life cycle of this equipment is over, it is
recommended that the frame and all other metal parts
be sent to a recycling center.
Metal recycling involves the collection of metal from
discarded products and its transformation into raw
materials to use in manufacturing a new product.
Recyclers and manufacturers alike promote the process
of recycling metal. Using a metal recycling center
promotes energy cost savings.
EMISSIONS INFORMATION
NOTICE
The gasoline engine used in this equipment has been
designed to reduce harmful levels of carbon monoxide
(CO), hydrocarbons (HC) and nitrogen oxides (NOx)
contained in gasoline exhaust emissions.
In the installed confi guration, this engine has been certifi ed
to meet US EPA evaporative emissions requirements.
Attempting to modify or make adjustments to the engine
emission system by unauthorized personnel without proper
training could damage the equipment or create an unsafe
condition.
Additionally, modifying the fuel system may adversely affect
evaporative emissions, resulting in fi nes or other penalties.
Emission Control Label
The emission control label is an integral part of the emission
system and is strictly regulated.
The label must remain with the engine for its entire life.
If a replacement emission label is needed, please contact
your authorized engine distributor.