![background image](http://html1.mh-extra.com/html/multiquip/sidewinder-hs81/sidewinder-hs81_operations-and-parts-manual_1855051023.webp)
HS81 CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #4 (09/12/05) — PAGE 23
The CLOSED position of the choke lever
enriches the fuel mixture for starting a COLD
engine. The OPEN position provides the
correct fuel mixture for normal operation after
starting, and for restarting a warm engine.
HS81 CUT-OFF SAW — INITIAL START-UP/OPERATION
DO NOT
attempt to operate the saw until
the Safety, General Information and
Inspection sections of this manual have
been read and thoroughly understood.
Depending on engine manufacturer,
operating steps may vary. See engine
manufactures operating manual.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
NEVER
operate the saw in a
confined area or enclosed
area structure that does not
provide ample
free flow of air
.
ALWAYS
wear approved eye and hearing
protection before operating the saw.
NEVER
place hands or feet inside the belt
guard or blade guard while the engine is
running.
ALWAYS
shut the engine down
before performing any kind of maintenance
service on the saw.
INITIAL START-UP
Fuel Check
Motor fuels are highly flammable and can be
dangerous if mishandled.
DO NOT
smoke
while refueling.
DO NOT
attempt to refuel the
saw if the engine is
hot!
or
running
.
Explosive Fuel
1. Remove the fuel cap located on the side of the saw.
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with
fuel oil mixture
as shown in Figure 22.
3. When refueling, be sure to use a strainer for filtration.
DO
NOT
top-off fuel. Wipe up any spilled fuel.
Starting
1. Place the engine ON/OFF switch in the
ON
position
2. Using your thumb, press down on the throttle lock lever,
while squeezing the throttle trigger. This will lock the throttle
in the
half-throttle
position.
3. Pull the choke lever all the way out to the
CLOSED
position.
4. Pull the
decompression button
outward.
5. Place the saw on level ground. Make sure the saw blade is
free to rotate and will not come into contact with any foreign
objects.
6. Hold the front handle firmly with the left hand and put your
right foot onto the base of the rear handle.
NOTE
This saw uses a 2-stroke engine which
requires a mixture of
premium
92 octane
unleaded gasoline and smoke free 2-stroke
motor oil. See Figure 22.
Figure 22. Fuel to Oil Mixture
NOTE
For correct fuel to oil mixture, add 2.6 fl. oz
(29.6 ml) of 2-stroke motor oil to 1 gallon (3.8
liters) of
premium 92 octane unleaded
gasoline
. For a
5 gallon
can of
premium
unleaded gasoline add 13 fl. oz (384 ml) of
2-stroke motor oil.
NOTE
A bottle ( 2.6 fl. oz) of smokeless 2-stroke motor oil
cannot be
purchased separately
. Only a case of 36 individual bottles can
be purchased. When ordering use Multiquip P/N 00325.