![background image](http://html1.mh-extra.com/html/multiquip/sidewinder-hs81/sidewinder-hs81_operations-and-parts-manual_1855051022.webp)
PAGE 22 — HS81 CUT-OFF SAW — OPERATION & PARTS MANUAL — REV. #4 (09/12/05)
WARNING
Failure to thoroughly inspect the diamond
blade (Figure 21) for operational safety
could result in damage to the blades or
the saw and may cause injury to the user
or others in the operating area.
Figure 21. Diamond Blade
BLADES
Saw blades, or cutting disks, are available in either an abrasive
design or as diamond blades. Either blade will work on the
HS81 CUT-OFF SAW , however, diamond blades are recommended.
Ask your dealer about your specific cutting application.
SAW BLADE INSPECTION
1.
Stress Relief Holes (Gullets)
- Check the steel core for
cracks that may have propagated from the slots and/or
gullets. Cracks indicate extreme fatigue failure and if sawing
continues, catastrophic failure will occur.
HS81 CUT-OFF SAW — BLADES
2.
Edge of the Steel Core
- Check the diameter edge for
discoloration (blue oxidation) indicating an overheating
condition caused by insufficient cooling water/air.
Overheating of blades may lead to loss of core tension and/
or increase the possibility for blade failure. Make sure the
steel core's width is uniform about the rim of the blade, and
not succumbing to an "under-cutting" condition brought
about by highly abrasive material or improper under-cutting
core protection
3.
Directional Arrow
- Ensure that the blade is oriented
properly on the blade shaft for sawing. Reference the
directional arrow on the blade and place it so the direction
of rotation "downcuts" with the turn of the shaft.
4.
Diamond Segment or Rim
- Ensure there are no cracks,
dings, or missing portions of the diamond segment/rim.
DO
NOT
use a blade that is missing a segment or a portion
of the rim.
Damaged and /or missing segments/rims may
cause damage to your saw or injury to the user or others in
the operating area.
5.
Specifications
- Ensure that the blade specifications, size,
and diameter properly match up to sawing operations.
Utilizing a blade not matched properly to the task may result
in poor performance and/or blade damage.
6.
Arbor Hole
- It is essential that the arbor hole diameter
properly matches the blade, and that it is free from distortion.
Correct blade flanges (collars) must be used. The inside
face of the flanges must be clean and free of debris. An out-
of-round arbor condition will cause damage to the blade
and the saw.
7.
MAX RPM
- This RPM reference is the maximum safe
operating speed for the blade selected.
NEVER
exceed the
max RPM on the diamond blade. Exceeding the maximum
RPM is dangerous and may cause poor performance and
may damage the blade.
PREPARATION / PRE-INSPECTION
1. Read and fully understand this manual,
the safety instructions in particular, and
the engine manufacturer's manual
supplied with the saw.
2. Select the correct blade for each application. If abrasive
blades are used,
MAKE CERTAIN
they are designed for
use on a concrete floor saw. They must be reinforced and
have a hole for the driving pin. When wet cutting with an
abrasive blade,
MAKE CERTAIN
the blade is intended for
wet cutting. Water will destroy a dry cut abrasive blade.
Some diamond blades require water cooling and failure to
do so will destroy them almost immediately. Other diamond
blades can be used with or without water.
3. Handle all blades with care and
NEVER
use a damaged
blade.
NEVER
use an abrasive blade that has been
dropped.