![background image](http://html1.mh-extra.com/html/multiquip/em120/em120_operation-and-parts-manual_1854959009.webp)
EM120 HYD. PLASTER/MORTAR MIXER• OPERATION AND PARTS MANUAL — REV. #1 (09/09/19) — PAGE 9
SAFETY INFORMATION
NOTICE
NEVER
run engine without an air fi lter or with a dirty air
fi lter. Severe engine damage may occur. Service air fi lter
frequently to prevent engine malfunction.
NEVER
tamper with the factory settings
of the engine or engine governor. Damage
to the engine or equipment can result
if operating in speed ranges above the
maximum allowable.
FUEL SAFETY (GASOLINE MODELS ONLY)
DANGER
DO NOT
start the engine near spilled fuel or combustible
fl uids. Fuel is extremely fl ammable and its vapors can
cause an explosion if ignited.
ALWAYS
refuel in a well-ventilated area, away from
sparks and open fl ames.
ALWAYS
use extreme caution when working with
fl ammable
liquids.
DO NOT
fi ll the fuel tank while the engine is running
or hot.
DO NOT
overfi ll tank, since spilled fuel could ignite if it
comes into contact with hot engine parts or sparks from
the ignition system.
Store fuel in appropriate containers, in well-ventilated
areas and away from sparks and fl ames.
NEVER
use fuel as a cleaning agent.
DO NOT
smoke around or near the
equipment. Fire or explosion could result
from fuel vapors or if fuel is spilled on a
hot engine.
GENERATOR SAFETY
(ELECTRIC MODELS ONLY)
If using a generator to power mixer, refer
to applicable generator manual safety
information section.
ELECTRIC MOTOR SAFETY
(ELECTRIC MODELS ONLY)
NOTICE
Operate electric motor only at the specifi ed voltage
indicated on the nameplate.
DO NOT
spray water onto electric motor.
ALWAYS
disconnect AC power plug from power source
before moving mixer.
ALWAYS
make sure the ON/OFF switch
on the electric motor is in the OFF position
when not in use and before inserting the
mixer’s power plug into an AC receptacle.
Power Cord/Cable Safety
DANGER
NEVER
let power cords or cables
lay in water.
NEVER
use
damaged
or
worn
cables or cords when
connecting equipment to generator. Inspect for cuts in
the insulation.
NEVER
grab or touch a live power
cord or cable with wet hands. The
possibility exists of
electrical shock,
electrocution or death.
Make sure power cables are securely connected.
Incorrect connections may cause electrical shock and
damage to the mixer.