![background image](http://html1.mh-extra.com/html/multiquip/bs90c/bs90c_operation-and-parts-manual_1855346021.webp)
BS90C WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #0 (9/4/15)— PAGE 21
THROTTLE CABLE INSTALLATION
Refer to Figure 12 for the location of components.
Figure 12. Throttle Cable Installation
1. Uncoil the throttle cable and housing.
2. Feed the throttle cable through the cable housing.
3. Connect the
trowel throttle cable
to the engine
throttle linkage (Figure 13). There should be a piece
of wire installed on the trowel to show where to route
the throttle cable.
4. Route
cable end
through the
cable locking screw
.
When connecting the
cable housing
, make sure that
no more than 1/4" (6.4 mm) of the
cable housing
protrudes past the
housing clamp
on the engine.
5. Tighten
cable clamp
screw.
6. After the trowel throttle cable has been connected to
the engine throttle linkage, adjust and tighten operator
position of the T-bar handle to lock the throttle cable at
the proper length.
THROTTLE
CABLE
ENGINE
THROTTLE
LEVER
1/4”
(6.35 MM)
CABLE HOUSING
CLAMP/SCREW
CABLE
LOCKING
SCREW
7. Adjust cable tenstion by loosening or tightening the
locking nut and cable retaining screw on the throttle
lever (see Figure 13).
Figure 13. Adjusting Cable Tension
INSTACLUTCH CABLE INSTALLATION
1. Uncoil the free end of the clutch cable.
2. Check that the clutch cable (Figure 14) is attached to
the handlebar cable anchor.
Figure 14. Handlebar Clutch Cable
3. Check that the clutch cable is fed along the tube and
secured with zip ties.
IDLE
RUN
THROTTLE
LEVER
LOCKING
NUT
THROTTLE CABLE
RECEIVER
CABLE
RETAINING
SCREW
THROTTLE
CABLE
THROTTLE
WIRE
NOTICE
If the throttle lever does not return to the "neutral"
position with throttle backed off, loosen adjusting nut
1/2 turn at a time, tighten and recheck. Readjust throttle
tension as necessary.
CABLE
ANCHOR
HANDLEBAR
CLUTCH
CABLE
ASSEMBLY AND INSTALLATION
Summary of Contents for BS90C
