Multiplex PARTENAVIA P.68 Manual Download Page 25

Page: 25 / 40

3. Set item value (Programmable value)

You will hear several tones in loop. Set the value matching to a tone by moving throttle stick to
top when you hear the tone, then a special tone “ 1515” emits, means the value is set and
saved. (Keeping the throttle stick at top, you will go back to Step 2 and you can select other
items; or moving the stick to bottom within 2 seconds will exit program mode directly)

User Manual of Brushless Speed Controller

Trouble Shooting

Note:

Please make sure the throttle curve is set to 0 when the throttle

stick is at bottom position and 100% for the top position.
1. Enter program mode

2. Select programmable items
3. Set item’s value (Programmable value)
4. Exit program mode

Program the ESC with your transmitter (4 Steps)

Trouble

Possible Reason

Action

After power on, motor does not work, no sound is
emitted

- The connection between battery pack
and ESC is not correct

- Check the power connection
- Replace the connector

After power on, motor does not work, such an alert
tone is emitted: “beep-beep-, beep-beep-,beep-
beep-” (Every “beep-beep-” has a time interval of
about 1 second)

- Input voltage is abnormal, too high or
too low

- Check the voltage of battery pack

After power on, motor does not work, such an alert
tone is emitted: “beep-, beep-, beep- ”(Every “beep-”
has a time interval of about 2 seconds)

- Throttle signal is irregular

- Check the receiver and transmitter
- Check the cable of throttle channel

After power on, motor does not work, such an alert
tone is emitted: “beep-, beep-, beep-” (Every “beep-”
has a time interval of about 0.25 second)

- The throttle stick is not in the bottom
(lowest) position

- Move the throttle stick to bottom
position

After power on, motor does not work, a special tone
“ 56712” is emitted after 2 beep tone (beep-beep-)

- Direction of the throttle channel is
reversed, so the ESC has entered the
program mode

- Set the direction of throttle channel
correctly

The motor runs in the opposite direction

- The connection between ESC and the
motor need to be changed

- Swap any two wire connections between
ESC and motor

1. Enter program mode

1) Switch on transmitter, move throttle stick to top position,
connect the battery pack to ESC
2) Wait for 2 seconds, the motor should emit special tone like
“beep-beep-”
3) Wait for another 5 seconds, special tone like “ 56712”
should be emitted, which means program mode is entered.

4. Exit program mode

There are 2 ways to exit program
mode:

1. In step 3, after special tone
“ 1515”, please move throttle
stick to the bottom position within
2 seconds.

2. In step 2, after tone “beep----
-beep-----”(th at is: The item #8),
move throttle stick to bottom
within 3 seconds.

2. Select programmable items

After entering program mode, you will hear 8 tones in a loop with the
following sequence. If you move the throttle stick to bottom within 3
seconds after one kind of tones, this item will be selected.

Note: 1 long “beep-----” = 5 short “beep-”

1. “beep”

brake

(1 short tone)

2. “beep-beep-”

battery type

(2 short tone)

3. “beep-beep-beep-”

cutoff mode

(3 short tone)

4. “beep-beep-beep-beep-” cutoff threshold

(4 short tone)