1
14
15
2
3
4
5
6 7
8
9 10
9
2. Overview MULTIGyro G3
3. Features
2.1 Overview LED display
“IN” area
Model type selection (jumper)
1
Flight mode changeover switch
8
J1 – V-tail
2
Aileron
9
J2 – Delta wing or flying wing
3
Elevator
10
J3 – Standard aircraft model
4
Rudder
“OUT” area
Gyro gain adjustment
5
Aileron
11
Potentiometer rudder
6
Elevator
12
Potentiometer elevator
7
Rudder
13
Potentiometer aileron
Supported model types:
Standard
aircraft
Aircraft with
a V-tail
Delta wing or
flying wing
4. Technical data
1
1
2
3
1
3
2
1
1
2
3
LED display
14
Red LED
15
Blue LED
Status
LED display
Description
Initialisation
The blue and red LEDs flash rapidly for three
seconds after switching on the gyro.
Initialised.
Do not move the aircraft
until initialisation
has been completed!
Blue LED flashes after initialisation.
Initialisation successful.
Red LED flashes rapidly after initialisation.
Initialisation failed. Undefined model type. Check the
adjustments J 1-2-3.
Operation
Blue LED illuminated permanently.
Standard mode. Ready for flight.
Red LED illuminated permanently.
Heading hold mode. Ready for flight.
Both LEDs are off.
Gyro is deactivated. Ready for flight.
· It is possible to toggle between three flight modes while
your model is airborne: 1. Off / 2. Standard / 3. Heading hold
· MULTIGyro G3 supports three model types:
1. Standard aircraft / 2. Delta wing or flying wing /
3. Aircraft with a V-tail
· Specially optimised for 3D flight.
· Independent gyro adjustment and gyro reversing for each
channel.
· Small and lightweight, thus also suitable for smaller aircraft.
1
Aileron servo
2
Elevator servo
3
Rudder servo
Voltage range
5 - 6V DC
PWM output
50Hz, or 20ms
PWM signal
1520±500µs
Full scale range
970~2070µs
Gyro sample rate
1KHz
Operating temperature
-40°C to 85°C
Dimensions
47 x 33 x 14 mm
Weight
11 g
11
12
13
