![background image](http://html1.mh-extra.com/html/multilaser/w-fit/w-fit_user-manual_1854462012.webp)
12
www.multilaser.com.br
Placement of the W Fit
The Fitness Board should be located directly in front of your TV as shown below, with the Wii Remote between 3 and 10 feet (1 and 3 meters) from
the Sensor Bar. The Power Button faces away from the TV.
FOLLOW THESE GUIDELINES WHEN USING THE W Fit:
. Make sure you have adequate space between you and any other objects or people during gameplay. The manufacturer recommends at least 3
feet (1 meter).
. Place the board on a stable, flat, horizontal surface. Avoid slippery surfaces.
. The balance sensors must contact the floor directly for proper operation. If carpet or other material contacts the bottom of the board, use the
included foot extensions. See page 10 for installation instructions.
IMPORTANT: The W Fit will not work until it has been synchronized with your Will console.
Synchronizing the W Fit with your Wii Console
IMPORTANT:To operate correctly, the W Fit must be synchronized with the Wii console using Standard Mode Synchronization. Follow the steps
below to synchronize the board to the console.
. This procedure must be followed for each W Fit compatible Game Disc.
. These synchronization settings will be saved even if the console is turned off.
. This procedure can be completed only if a compatible Game Disc is running in the console.
1. Press the EJECT Button on the front of the Wii console and remove any game disc if necessary. Insert a W Fit compatible Game Disc.
2. Use the Wii Remote to select the Disc Channel on the Wii Menu screed and select START.
3. Open the SD Card slot cover on the front of the Wii console.
NOTE: Close the SD Card slot cover when you are finished with the synchronization procedure.
4. Remove the Battery Cover on the bottom of the W Fit.
NOTE: Replace the Battery Cover when you are finished with the synchronization procedure.
5. Press the SYNCHRO Button (SYNC.) on the W Fit. The Power LED on the board will start blinking (for up to about 20 seconds).
6. Press the SYNCHRO Button (SYNC.) on the console while the Power LED on the board is blinking.
﹗
﹗
﹗
﹗
js055_manual.indd 12
14/02/2011 12:12:18