Multilaser AU602, User Manual

Page: 20 / 24

20
AC adapter/charger charging:
Plug the Adapter/charger into an AC power outlet and put the other (output DC 12V) end into the receptacle(beside DC
charging LED(No.11,see figure 1)on the front panel of your power booster until the battery meter shows full(14 to 15 DC)
12V DC/DC power cord charging
Insert the cigarette lighter plug of the 12V DC/DC adapter/charger(No.8,see figure 1) into an 12V DC cigarette lighter
receptacle(on your vehicle or boat )and put the other (output )end into the receptacle (beside DC charging LED No.11,see
figure 1)on the front panel of your power booster until the battery meter shows full (14 to 15V DC )
3.5 Operation
3.5.1. To use your power booster as a 12V DC/DC power source:
• Life up the cover of 12V DC cigarette lighter receptacle (see No.1 of figure 1)
• Insert the 12V DC cigarette lighter plug from the appliance into the 12V DC cigarette lighter receptacle on the side of
your booster
The following table will give you an idea of what operation time you can expect when starting from a fully charged system.
Appliance type Estimated power comsumption (in wats) Estimated usage time (in hours)
Fluorescent lights cell phones 4 30
Radios, fans, depth finders 9 21
Camcorders, VCR’s spotlights 15 12
Electric tools ,bilge pumps 24 7
Electric coolers 48 3
Air compressors ,car vacuums 80 1.5
3.5.2 Jump Starting
For performance when using your power booster to jump start a vehicle or boat, please read and follow these step by
step instructions:
1. Connect the red (+) alligator clamp to the red (+) positive battery terminal or the vehicle or boat.
2. Connect the black (-) alligator clamp to a non-moving metal part of the engine, NOT to the (-) negative battery terminal.
3. Wait a minute or two
4. Turn on the Power Switch then switch the vehicle or boat engine ignition to “start” for no more than 5 to 6 seconds.
5. If the vehicle or boat engine does not start, wait at least 3-minutes before trying again.
6. Once the engine is running, disconnect the black (-) clamp first and return this cable to its stored position on the power
booster.
3. Instructions