Multicomp-Pro
25
Figure 4-3 Set the network parameters of the Oscilloscope Software
(4)
Set the network parameters of the oscilloscope
. In the oscilloscope, click the
icon, click
Utility
. Select
Function
in the bottom menu. Select
LAN Set
in the left
menu. In the bottom menu, set the
Type
item
as
LAN
, and select
Set
. In the right
menu, set
IP
and
Port
to the same value as the "Ports-settings" in the software in step
(3). Select
Save set
in the bottom menu, it prompts "Reset to update the config". After
resetting the oscilloscope, if you can get data normally in the oscilloscope software,
the connection is successful.
Figure 4-4 Set the network parameters of the oscilloscope
Connect through a router
(1)
Connection
. Use a LAN cable to connect the oscilloscope with a router, the LAN port
of the oscilloscope is in the right panel; the computer should be connected to the
router too.
(2)
Set the network parameters of the computer
. Since the oscilloscope can not
support obtaining an IP address automatically, you should assign a static IP address.
