multicomp pro MP720644, Quick Manual

Page: 13 / 33

Multicomp-Pro
11
How to Set the Probe Attenuation
Coefficient
" on P11), and connect the
probe with the CH1 channel. If a probe hook tip is used, ensure that it keeps in
close touch with the probe. Connect the probe tip with the signal connector of the
probe compensator and connect the reference wire clamp with the ground wire
connector of the probe connector, and then push the
Autoset button on the front
panel.
2. Check the displayed waveforms and regulate the probe till a correct
compensation is achieved (see
Figure 3-6 and Figure 3-7 ).
Overcompensated Compensated correctly Under compensated
Figure 3-6 Displayed Waveforms of the Probe Compensation
3. Repeat the steps mentioned if needed.
Figure 3-7 Adjust Probe