12
Arm/Disarm for AlarmLINK (Optional)
Arm/Disarm Configuration: steps required
1. Configure a zone on the alarm panel to
“Arm/Disarm input” (program as momentary
key switch).
2. Enable reporting of open/close reports. Do
this for both ‘stay’ and ‘away’ modes. This step
is important as t
he AlarmLINK app will not show
the request was successful until the open/close
report is received at the Monitoring Centre.
By default the Multicom is pre-configured to
pulse ‘Relay 2’ for 3 seconds on arm disarm
request.
3. Program the alarm panel entry and exit
delays to the ‘minimum time’ to speed up the
AlarmLINK arm/ disarm response time.
Please complete the configurations on
this step before proceeding to Step 7.
