Multi-Tech MT5600BA, User Manual

Page: 44 / 118

MultiModemII User Guide
36
Command: S r Select Register
Values: r = S-register number
Default: None
Description: Selects register Sr as the last register accessed. E.g., S0. The
command AT? can then be used to read the register, and the
command AT=n can then be used to set the register to value n.
Command: S r=n Set Register Value
Values: r = S-register number; n varies
Default: None
Description: Sets value of register Sr to n, where n is entered in decimal
format. E.g., S0=1. If the short form AT=n is used, the value is
written to the last accessed S-register.
Command: S r? Read Register Value
Values: r = S-register number
Default: None
Description: Reads value of register Sr and display it in 3-digit decimal
format. E.g., S2? gives the response 043. If the short form AT?
is used, the last accessed S-register is read.
Command: T Tone Dialing
Values: P, T
Default: T
Description: Forces DTMF (touch-tone) dialing until a P command or P dial
modifier is received.
Command: V n Result Code Format
Values: n = 0 or 1
Default: 1
Description: V0 Displays result codes as digits (terse response).
V1 Displays result codes as words (verbose response).
Command:
W
n
Connect Message Control
Values: n = 0, 1, or 2
Default: 0
Description: W0 The CONNECT result code reports the serial port speed. Other
responses are disabled.
W1 The CONNECT result code reports the line speed, the error
correction protocol, and the serial port speed, respectively.
Other responses are disabled.
W2 The CONNECT result code reports the line speed only. Other
responses are disabled.
Note: See also the \V command