NETWORK MANAGEMENT
mDot
TM
AT Command Reference Guide
49
Command
AT+ENC?
AT+ENC=?
Parameters and Values
Parameter1
0
Disabled
1
Enabled (Default)
Command with Response Examples
AT+ENC=1
OK
AT+ENC?
1
OK
help AT+ENC
AT+ENC: Enable/disable AES encryption (0: off, 1: on)
OK
AT+ENC=?
AT+ENC: (0,1)
OK
Manual Activation
If supported by the network server, the Dot can be activated manually. To do this, configure the network address,
network session key, and data session key.
AT+NA
Network Address
Sets network address in MANUAL join mode, the server will assign an address in OTA modes. (Supports modifying
8 multicast sessions, which can be saved and restored using AT+SS/AT+RS).
Note
: There are two options for this command using either one or two parameters. For unicast, use one parameter
(parameter1) to set or return the unicast value. For multicast, use two parameters (parameter1, parameter2) to
set or return the multicast value (where parameter1 is the multicast session number and parameter2 is the
multicast value).
Syntax
Command
AT+NA=<parameter1>,<parameter2>
