Basic control principles
Switching the display to ON.
5
31302713-02-US
V9.20191001
17
Basic control principles
Switching the display to ON.
To switch on the display:
The display is installed and connected to the power cable or the ISOBUS basic vehicle harness.
1.
Press and hold the
button for approx. 3 seconds.
⇨
The display will beep briefly.
⇨
The display screen remains dark for approx. 10 seconds until the applications are loaded in
the background.
⇨
The start-up screen of the display will appear:
⇨
You have now started the display.
Initial start-up
The next step to perform after switching on the display depends on the purpose of the display:
▪
Parallel guidance
▪
Operation of ISOBUS implements
▪
Automatic boom section control
▪
Task management and documentation
These cases will be described in the following sections.
Using the display for parallel guidance
If you want to use the display for parallel guidance, TRACK-Leader is the most important app for you.
Most important settings
Setting
Where?
Purpose
Select the GPS driver.
/ Driver / GPS [
The standard driver works in
most cases for the receivers
sold by ME. However, to
change the correction signal, a
fitting driver for the GPS
receiver must be activated.
5
5.1
Procedure
5.2
5.2.1
