Muji AD-SD1-SG, User Manual

Page: 13 / 48

-12-
8. Fill with water and essential oil
* Never plug in this
product when the
water tank is empty.
Doing so may result
in damage to the
ultrasonic diaphragm,
malfunction, or leak.
9. Connect the
AC adapter to
an electrical outlet.
・
Be careful not to spill water while filling the water tank.
・
Add a few drops of essential oil to the water in the water tank.
* Always use the attached measuring cup (100ml) to fill the
water tank.
* Never attempt to pour water in through the diffuser outlet or
fill the water tank directly from a tap.
Doing so may result in product malfunction.
* Fill the tank to a maximum of 100ml or less.
Mist will not operate normally if the tank is overfilled (100ml)
* Do not lean the diffuser unit at an angle when filled with water.
Doing so may allow water to enter inside the unit through the
air outlet resulting in malfunction.
* Standard for essential oil is between two and three drops
(approximately 0.1 to 0.2ml) for 100ml of water (full tank).
* Mist will not operate normally if the outer cover and inner
cover are not aligned or there is a gap between the outer
cover and the body of the diffuser unit.
* When removing the outer cover while there is water in the
water tank, always set the diffuser unit on a desk or
similar surface. Do not tilt the diffuser at an angle.
・
Confirm that the outer cover and
inner cover are properly positioned.
・
After replacing the outer cover, gently
turn clockwise (as seen from the top).
・
Turn the outer cover until the
alignment marks on the outer
cover and the main unit align.
10. Replace the cover
Alignment
marks