5.
Using furnished wiring harness route 10ga red power wire starting at pre-amp
location (center rear wall of truck). Route wire on drivers side, over to threshold
and under carpet to the front of vehicle.
6.
Open hood.
7.
Drill a hole through the fire wall. Locate a spot low on the fire wall on the pas-
senger side. You should always look to find a clear path. Drill a hole from inside
of the vehicle into engine compartment and insert grommet. You may also find a
pre-existing, unused rubber grommet in this location that you can pass the wire
through.
Firewall
Battery
Drill Hole
for Grommet
Note: To avoid any damage to parts inside engine compartment, drill from
inside of vehicle using a short bit.
8.
Route 10ga red power wire through a grommet into the engine compartment.
9.
Route 10ga red power wire through engine compartment safely away from any
moving or hot parts that could damage the wire.
10.
Cut 10ga red power wire to length, connect the supplied fuse holder from the
wire kit to the end of the wire.
Setting Crossover
You should set the crossover to your own personal listening taste. The cross-
over is adjustable to any frequency between 50Hz (counterclockwise) to 150Hz
(clockwise). As a guideline, the goal is to create the illusion of bass up front. The
higher the crossover point the more “audibly visible” your sub is going to be. Take
your time and really listen to your system, grab a soda and a few of your favorite
tunes and have fun.
TROUBLESHOOTING TIPS IF AMP DOES NOT TURN ON
Check all connections at battery and that fuse is installed
Check speaker wire connections
Check ground
Check fuse on pre-amp
19.
Reinstall threshold trim. Locate and align holes in vehicle with pins on trim;
and snap back into place.
20.
Push enclosure back against the rear wall of truck.
21.
Using the supplied hardware, secure the enclosure to floor of vehicle as
shown below.
2
5
