25cm 10“ 200W RMS
Class-D Powered Enclosure
EBC Remote
Control
High Level
Inputs
Gain Control
4V~0,1V
Ch.1
Ch.2
Power
+12V
Rem.
GND
Protection
Input
+
-
- +
Left
Right
Owner
’s M
anual - M
TX RTF10P
Thank You !
Thank you for purchasing an MTX Audio High-End powered enclosure. Proper installation matched with MTX speakers and powered
enclosures provide superior sound and performance for endless hours of waking the neighbors, slammin’ your friends or flat out
stomping wanna-be players. Congrats and enjoy the ultimate audio experience with MTX !
Specifications :
• Powered sealed shallow enclosure
• Subwoofer : 25cm (10“)
• Class-D mono block Amplifier
• Peak Power : 600W
• RMS Power : 200W
• EBC remote included
• High and low level inputs
• Dimensions : 34x48x13cm
Power Terminal (+12V) : This is the main power input for the amplifier and must be con-
nected directly to the positive terminal of the vehicles battery for proper operation. Use
caution when installing (+12V) power cable in the vehicle. Avoid running this cable par-
allel with RCA cables, antennas, or other sensitive equipment due to massive currents that
can induce noise into the audio system. It is also very important to have a tight, secure
connection for maximum performance. MTX recommends using a minimum of 10mm2 full
copper power wire with the MTX RTF10P.
Remote Terminal (REM) : The amplifier can be turned on by applying 12 volts to this ter-
minal. Typically this voltage is supplied by a wire from the source unit marked “remote”
or “power antenna”.
Ground Terminal (GND) : A proper ground is required for your amplifier to operate at peak
performance. A short ground cable the same diameter as the power cable should be used
to attach the ground terminal directly to the chassis of the vehicle. Always remove paint,
dirt or debris to expose bare metal where the ground will be attached.
Protection LED (Prot.) : When the amp is in thermal protection, the LED turns to red.
PowerOn LED (PWR.) : The LED illuminates red when the amp is switched on.
RCA Inputs (Input) : These RCA inputs are used with source units that have RCA or Line level
outputs. (Source units need a minimum level of 100mV output for proper operation of the
amplifier). MTX recommends only high quality RCA cables to decrease the possibility of
radiated noise entering the system.
Gain Control (Gain) : The gain control matches the input sensitivity of the amplifier to the
source unit being used.
The operating range varies from 100mv to 4V. Adjusting the gain:
1. Turn the gain control on the amplifier all the way down (counter clockwise).
2. Turn up the volume control on the source unit to approximately 3⁄4 of maximum.
3. Adjust the gain control on the amplifier until audible distortion occurs.
4. Adjust the gain control down until audible distortion disappears.
5. The amplifier is now calibrated to the output of the source unit.
Speaker level inputs (High Level Input) : This input will allow the amplifier to operate from
source units with speaker-level outputs. Output speaker leads from the source unit should
be tied directly to the wire harness provided with the amplifier.
Note : When speaker level inputs are used, a remote turn on wire must used to switch the
amplifier on and off.
B ass remote control port (EBC) : use this port to connect the optional MTX EBC. It alows you
to control the output level siting at the front of the car.
Control Panel on the Amplifier :
