068 – SS T-Coolant
Red alarm. Engine shutdown.
Associated parameter 2.0120.932
Cause
Corrective action
Coolant temperature after
engine too high (limit value 2).
Engine coolant pump failure,
volumetric flow too low, air in
engine coolant circuit.
u
Check engine coolant circuit.
089 – SS Engine Speed too Low
Red alarm. Engine shutdown.
Associated parameter 2.2500.030
Cause
Corrective action
Engine stalls. In normal
operation the engine speed is
below the limit set in parameter
2.2500.027 (Engine stall speed
limit) without an engine stop
having taken place. The engine
is shutdown for safety reasons.
1. In parallel operation connected to mains:
• Check mains for frequency drop.
• Check generator and coupling for damage.
2. In isolated operation:
• Check throttle position.
• Check throttles for implausible closing. If throttles are fully
open: Check if load step values are admissible.
• Check bypass position.
• Check air filter for contamination, replace if contamination is
visible (→ Page 151).
• Check exhaust back pressure.
• Check differential pressure over mixture cooler.
• Check emissions and injection timing (→ Page 141).
• Check oil separator efficiency (oil in compressor intake
elbow), clean compressor as necessary.
• Check valve clearance (→ Page 145).
• Check gasket between mixture line and cylinder head for
correct installation position.
090 – SS Starter Speed Not Reached
Red alarm. Start terminated.
Associated parameter 2.1090.925
Cause
Corrective action
Idle speed not reached.
1. Check ignition.
2. Check gas supply.
3. Check mixture setting.
091 – SS Release Speed Not Reached
Yellow alarm
Associated parameter 2.1090.924
Cause
Corrective action
Gas temperature sensor
defective, short circuit or wire
break.
1. Not installed in all engine versions (optional).
2. Check sensor and cabling (B38), replace as necessary.
100 | Troubleshooting | MS150103/01E 2015-03
TIM-ID: 0000038612 - 001
